Starting your washer
Before starting
your washer:
1. Measure and add detergent.
2. Place sorted load In washer.
3. Start washer.
Select a
Select WATER
1. LOAD SIZE
2. TEMPERATURES
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob anywhere on or be-
tween HAND WASHABLE (a few small
items) and EX LARGE [a full load).
See your “Laundry Guide” for details
on load sizes.
NOTE: Use the EX LARGE water
level for best permanent press
results.
l
Select wash and rinse water tem-
peratures by pushing a button.
. This drawing shows a warm wash
[top temperature) and cold rinse
(bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Guide:
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
8
CAUTION :
DO NOT
OVERLOAD WASHER.
*Approximate
fill with load.
EX LARGE (21.7 galsJ82.1L)’
MEDIUM (16.4 gals.162.1L)’
HAND WASHABLES (11.9 gals./45OL)’
4
To Next Page
Loading...
