7
9. Snap plastic shield over water valve nozzle.
10. Plug connector from the refrigerator machine compartment
into connector/terminals on the water valve.
11. Insert strain relief clip on power cord back into slot in rear
panel and reinstall panel using 6-9 screws removed in step 2
(refer to illustration in step 2 for screw locations B and strain
relief location C).
12. Secure excess water line tubing to cabinet with small plastic
adhesive clip included in ice maker kit. Position clip (A)
approximately halfway between ll tube and valve.
Water valve shield installation
A Clip
To Next Page
Loading...
