Whirlpool W10190965 - User Manual

INSTALLATION INSTRUCTIONS FOR ICE MAKER PART NO. W10190965
1. Unplug refrigerator or disconnect power.
2. Remove defective ice maker from freezer. The ice
maker may be held in place by three screws (Figure 1)
or by two clips and one screw (Figure 2).
IS025 (2/18)
To avoid risk of electrical shock, personal injury or death; disconnect electrical power before servicing.
WARNING! Electrical Shock Hazard
3. When replacing certain ice makers there will be a
mounting plate as an intregal part of the defective unit.
This must be removed and attached to the W10190965
(Figure 3).
FIG. 1 FIG. 2
4. Install lower bracket using the one on the defective unit
with a self tapping screw (Figure 4).
5. If the harness from the defective unit has a thermal
fuse, as shown in Figure 5A, reuse the harness. If the
harness does not have a thermal fuse or the thermal
fuse is blown, as shown in Figure 5B, you must
purchase a new wiring harness.
6. Remove knock-out from end as indicated in Figure 6.
FIG. 3
FIG. 4
FIG. 5A
FIG. 5B
Thermal fuses
7. Mount with screws removed from the defective unit.
Plug harness into the receptacle in freezer and mount
unit.
8. Check position of the inlet tube and position properly.
Make sure the shut off is in the down position.
9. Plug in refrigerator or reconnect power. It may take up
to 24 hours for your ice maker to begin producing ice.
FIG. 6

Summary

Installation Instructions for Ice Maker

Electrical Shock Hazard Warning

Warning to avoid electrical shock, personal injury, or death by disconnecting power before servicing.

Preparation and Removal

Steps to disconnect power and remove the defective ice maker from the freezer.

Mounting Plate and Bracket Installation

Instructions for attaching the mounting plate and lower bracket to the new ice maker unit.

Harness and Unit Installation

Guidance on reusing or replacing the wiring harness and mounting the new ice maker unit.

Final Checks and Power On

Checking the inlet tube, shut-off position, and restoring power to the refrigerator.

Modular Ice Maker Service and Testing

Electrical Shock Hazard Warning

Warning to avoid electrical shock, personal injury, or death by disconnecting power before servicing.

Module Test Points and Specifications

Details on module test points, resistance checks, voltage checks, and component specifications.

Service Procedures

Procedures for removing and reassembling the module, motor, shut-off arm, and other components.

Water Level Adjustment

Instructions on adjusting the water fill level by turning the screw, with guidance on adjustments.

Whirlpool W10190965 Specifications

General

Brand	Whirlpool
Model	W10190965
Category	Ice Maker
Language	English