Whirlpool WED94HEXW0 - Manual and Steam Cycle Guides; Manual Cycle Operation and Settings; Manual Cycle Types Explained; Steam Cycle Operation and Benefits

CYCLE GUIDE -- CYCLES
Settings and options shown in bold are default settings for that cycle.
Not all features and cycles are available on all models.
Not all settings and options are available on each cycle.
Adjusting drying time on Manual Cycles
When you select a Manual Cycle, the default
time appears in the display. Use the A and V
buttons to increase or decrease the time in 1
minute increments. Press and hold to change
the time in 5 minute increments.
The maximum dry time is 100 minutes.
Selecting the Drying Temperature
A High heat setting may be used for drying heavyweight items
such as towels and work clothes.
A Low to Medium heat setting may be used for drying
medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a no heat (air dry) setting for foam, rubber, plastic, or heat-
sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions.
_iii/ii _ _ii_ i i_i_:i_iii iii_iii_il _i_ _i_
,temstoary: cyoie:
Small loads and Quick Dry
sportswear
Any load
NOTE: Select Air
Only to dry foam,
rubber, plastic, or
heat-sensitive
fabrics.
Timed Dry
D ing
Temperature:
High
Medium
Low
Extra Low
Air Only,
High
Medium
Low
Extra Low
Air Only
Default
Time:
13
40
i i _I ii i_i
Available
Options:
Wrinkle Shield?
Wrinkle Shield?
Cycle Details: .........
For small loads of 3-4 items.
i _ Use to dry items to a damp level for items that do
I_ not require an entire drying cycle. Select a drying
i temperature based on the type of fabrics in your
load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the
higher setting.
? Or Wrinkle Shield with Steam (on some models). Wrinkle Shield with Steam is available only with High and Medium Drying Temperature settings.
CYCLE GUIDE- CYCLES
Settings and options shown in bold are default settings for that cycle.
Not all settings and options are available on each cycle.
Steam cycles are designed for use with dry loads to loosen wrinkles, remove odors, and refresh fabrics.
temsto I I uefau t
refresh: Cycle: Temperature: Time:
Shirts, blouses, Quick Refresh
and slacks with Steam
Mixed Loads Enhanced
Touch Up
(on some
models)
Medium 12 (15)*
High 22
Medium
Options:' Cycle Details:
Wrinkle Shield?
Static Reduce
Wrinkle Shield?
Static Reduce
i_ Use to remove odors and reduce light wrinkles.
i Select the number of garment to be refreshed
i (on some models). Do not add dryer sheets.
Use to remove wrinkles, including from loads left in
the dryer too long. Dry time will automatically adjust
when the load size is sensed. Cycle run time cannot
be manually adjusted, but Temperature is selectable.
Do not add dryer sheets
* 12 minutes on 11-cycle models. 15 minutes on 8-cycle models.
? Or Wrinkle Shield with Steam (on some models). Wrinkle Shield with Steam is available only with High and Medium Drying Temperature settings.
Load Size Recommendations
For best results, follow the load size recommendations noted for
each cycle.
@ mall load: Fill the dryer drum with 3-4 items,
not more than 1/4 full.
_ Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not overload. Items need to tumble freely.