Installation guide
whiskersuppo.comQuestions? VisitLR3-8198
Installing the
Lier-Robot 3
Waste Drawer
Liner
Open a new waste drawer liner and roll down
the edges four times.
Sta at the back of the waste drawer and push the
rolled edge of the bag into each of the four tabs,
making sure the bag is taut across the back and
sides. Pull the slack forward toward the carbon lter.
Make sure the bag does not come up past the top
of the sides of the waste drawer, which can result in
a false flashing blue "drawer full" light on the control
panel.
Slide the drawer closed and press the Reset
buon to zero the cat sensor.
How to install
1 3
4
2
To Next Page
