whisker Litter-Robot 4 Installation Guide

Installation guide
whiskersuppo.comQuestions? VisitLR4-8092
Installing the
Lier-Robot 4
Carbon Filter
Lier-Robot 4 is equipped with a flexible carbon
lter pad that is installed on the outer boom area
of the globe. This lter sits directly over the waste
drawer to absorb odours. (The carbon lter is not
required for the unit to function.)
Press and hold the Cycle and Empty
buons on the control panel for 3 seconds, or
tap “Replace Filter” under Controls in the app.
A clean cycle will begin; the cycle will pause
when the globe reaches the “replace lter”
position.
Open the bonnet: Press and hold the latches
on both sides of the bonnet, then li and
rotate the bonnet to its open position to
reveal the lter pocket.
Open the lter cover and replace the carbon
lter as needed. (Under normal use, 1 lter
should last approximately 1 month.)
Close the bonnet: Rotate the bonnet down-
ward over the globe and push down on the
bonnet from the top to make sure it is
latched and secure.
Press the Cycle or Reset buon to
resume the clean cycle; when the clean cycle
has ended, press the Reset buon to zero the
weight sensors.
1
2
3
4
5
6
How to install

whisker Litter-Robot 4 Specifications

General

Brand	whisker
Model	Litter-Robot 4
Category	Pet Care Product
Language	English