Ensure Proper Placement
Power On
Add Litter
Download The App
1
3
2
4
If possible, place the Litter-Robot in the same location
as the old litter box (at least during transition).
Make sure the unit is indoors on a firm, level surface and
in a cool, dry location.
Place litter mats or rugs in front of, or completely under,
the unit. Do not place mats partially under the unit. Use
only low pile (1/4 inch) mats or rugs under the unit.
Insert the small plug
end of the power cord
into the socket on the
back of the base.
The Litter-Robot will now perform an initial clean cycle. Need help? Visit litter-robot.com/help
LR3-8010-0d
Use clumping litter or litter beads and crystals that are
small enough to pass through the screen.
Add litter until it meets the raised fill line when spread flat
(about 8-10 pounds). Be careful not to overfill.
Download the AutoPets Connect app and follow the
onboarding instructions. (For Litter-Robot Connect units)
Litter Fill Line
Plug the AC/DC
adapter into a
wall outlet.
Press the Power
button on the
control panel.
To Previous Page
Loading...
Need help?
General
