WHISPBAR RAIL BAR
EN
S41W
Fitment
● Position one end of crossbar on the
opposite roof rail and swing the free end so
that the clamp is under the rail and the
rubber gasket sits on top.
● Repeat on other crossbar.
● Crossbars should be parallel to each other
and sit perpendicular to the roof rails.
● Pull legs out evenly until both rubber
gasket seal on roof rail.
● Ensure each end of the crossbar is
adjusted equally.
● Note that legs can pivot slightly to
accommodate for roof rail taper.
● Once crossbars are in position, tighten
screw to 5 Nm (3.7 ft lb).
● Repeat for all legs.
4
To Next Page
Loading...
