www.whisperkool.com | Page 15
Slide the hose clamps on the receiver over the silicone
heaters. One at the top of the heaters and one at the
bottom. Secure in place as shown.
Wrap the spring from the thermal switch around the
liquid line and secure the clasp of the spring to the
thermal switch as shown.
Slide the thermal switch to the location shown. Make sure the tab of the thermal switch rests on the
screw terminal of the top hose clamp.
43
44
45
NOTE: Make sure the surface of the thermal switch is located at the ridge of the receiver,
and is making good contact.
To Next Page
Loading...
