OPERATION
within a certain radius (selected in Option Select Mode). Once
a radius is selected the data can be deleted within the selected
Radius or they all can be deleted completely from memory.
X/K and Ka Filter Modes
There are times when a radar detector in another vehicle, can
emit a frequency which can cause your detector to falsely alert.
These Filter Modes allow you to select the level needed for your
area to minimize the occurrences of these false alerts. X/K and
Ka Filter Mode factory default settings should provide adequate
filtering for most conditions. If you experience excessive alerts
due to radar detectors in other vehicles, increase the Filter level
for the band received. See Option Selection Mode to change
the filter settings.
Speed Selectable Filter Mode
Traveling below the speed selected in option mode will apply
the maximum Filter.
NOTE: Enter Option Mode to set Speed Selectable Filter.
Ka Max Mode
Provides enhanced Ka sensitivity. This mode can be selected
with or without RSID.
Field Disturbance Sensor Rejection (FDSR)
Traffic Flow Sensor Rejection (TFSR)
Recently many new products that operate on police radar
frequencies have been causing nuisance alerts to radar
detectors. These radar based sensors are installed alongside
the Highway and more recently on vehicles used as lane change
assist / blind spot detectors / collision avoidance systems. TFSR
when turned ON is designed to eliminate alerts from specific
Traffic Flow sensors. FDSR when turned ON is designed to
identify all radar based collision avoidance systems that operate
within the same band as police radar and provide a brief
less intrusive alert to keep you informed and aware. A signal
strength indicator will help determine your proximity to the
source without the continued annoyance of audio.
We suggest you turn FDSR ON if you are experiencing
excessive random false alerts when behind select vehicles.
Press the Menu button to enter Option Select Mode. Each press
of the Menu button changes to the next selectable feature. The
Dark (D) button and the Quiet (Q) button turns the feature ON/
OFF or Blinking for example. A button must be pressed within
20 seconds or Option Select Mode will automatically be exited.
To Next Page
Loading...
Need help?
General
