Whistler PP500AC - Page 4

WHISTLER PP500AC
cZ
equipment or appliance, run a test. The WHISTLER 500 is designed to
automatically shut down in the event of a power overload and testing appli-
ances and equipment with ratings in the 500 watt range will not damage it.
If a piece of equipment or an appliance in the 500 watt range will not
operate properly when first connected to the inverter, turn the inverter
rocker switch ON (I), OFF (0), and ON (I) again in quick succession. If this
procedure is unsuccessful, it is likely thatthe WHISTLER 500 does not have
the required capacity to operate the equipment or appliance in question.
Note:
• Most heat generating appliances require start up loads in excess of
1000 Watts and the WHISTLER 500 will not operate such appliances
as coffee makers, irons, hair dryers or heaters.
WHISTLER PP500AC Inverter
Front View
a). ON/OFF Rocker Switch
b). LED Indicator Light. (GREEN = Power ON, RED = Overload)
c). Two Standard North American AC Outlets are provided
WHISTLER PP500AC Inverter
Rear View
d). High Speed Cooling Fan
e). 35 Amp Fuse Covers
f). Power Input Terminals (BLACK/Negative, RED/Positive)
g). Ground Terminal