Whitehall BALMORAL MAILBOX User Manual

A
B
C
D
B
C
FIG. 1A
FIG. 2A
B
C
BALMORAL MAILBOX
©2023 Whitehall Products, LLC Customer Service: 800.728.2164 www.whitehallproducts.com AW-1073
Need additional assistance? If you have questions about your mailbox you may call Whitehall Products Customer Service: 800.728.2164
MONOGRAM AND SIDE ADDRESS PLAQUE INSTALLATION
Parts Included:
On a flat clean surface, place the Side Plaques (B)
and Monogram (C) with the personalization facing
down.
Without removing the adhesive backing, place four
(4) of the provided tape squares (D) in the corners
of each Side Plaque (B) approximately 1/4”-1/2”
from each edge. Place one (1) tape square in the
center of the monogram. Be sure to give each
square enough space to avoid overlap or overhang.
(FIG. 1A)
Once evenly spaced, peel off one (1) plastic backer
of each adhesive tape square one by one and
replace EXACTLY with the sticky side down (TAPE
BONDS IMMEDIATELY). Press firmly for 15
seconds to FULLY activate adhesive. Repeat for
each tape square.
Once the tape is set, peel off the remaining plastic
backers. Ensure correct plaque orientation before
installation. The adhesive bonds IMMEDIATELY
and cannot be repositioned. At a 45 degree
angle, rest the bottom edge of the plaque along the
inside bottom edge of the recessed side
plaque/monogram frame on the mailbox (A) for
level application. Tilt plaque forward and press
firmly for 15 seconds to FULLY activate adhesive.
Repeat for each plaque. (FIG. 2A)
Enjoy your new personalized Balmoral Mailbox!
1)
2)
3)
4)
5)
Instructions:
Balmoral Mailbox
Side Plaques - 2 (optional)
Door Monogram (optional)
2” x 2” Adhesive Tape Squares - 12
A)
B)
C)
D)

Whitehall BALMORAL MAILBOX Specifications

General

Finish	Powder Coated
Mail Capacity	Large
Flag	Yes
Lock	No
Weather Resistance	Yes
Material	Aluminum
Mounting Type	Post-Mount

Summary

Balmoral Mailbox Monogram and Side Address Plaque Installation

Parts Included for Balmoral Mailbox

Lists components like mailbox, side plaques, door monogram, and adhesive tape squares.

Balmoral Mailbox Plaque Installation Instructions

Step-by-step guide for applying adhesive tape and mounting side address plaques and monograms.

Capitol Mailbox Address Side Plaque Tape Installation

Parts Included for Capitol Mailbox

Lists components: Capitol Mailbox, side plaques, and adhesive tape squares.

Capitol Mailbox Side Plaque Tape Installation Instructions

Guide on applying adhesive tape squares to side address plaques for installation.

Street-Side Mailbox Door Plaque Drilling Template

Street-Side Mailbox Drilling Instructions

Instructions for cutting out a template and drilling holes for mailbox door plaque mounting.

Capitol Mailbox Personalized Door Plaque Installation

Capitol Mailbox Door Plaque Components

Lists included parts: threaded studs, Allen wrench, door plaque, acorn nuts, and silicon sealer.

Capitol Mailbox Door Plaque Installation Steps

Step-by-step process for attaching personalized door plaques using studs, nuts, and sealer.