Why Whitehall Medical Equipment water is not getting hot?
If the Whitehall Medical Equipment water is not getting hot even when plugged in and switched on, it could be due to several reasons. First, the circuit breaker might be off; in this case, adjust the thermostat. Alternatively, the thermostat itself might be faulty and need replacement. Lastly, the heating element could be burned out, requiring replacement.
What to do if Whitehall Medical Equipment Thermal Packs are too cool?
If the Thermal Packs in your Whitehall Medical Equipment are too cool, it could be due to a few reasons. The thermostat might be set too low, so adjust the thermostat accordingly. Another possibility is a broken thermostat, which would require replacement. Finally, there might be a power failure; in this case, check the circuit and turn on the breaker.
Why Whitehall Thermalator LITTLE Therm Medical Equipment Thermal Packs are too hot?
If the Thermal Packs in your Whitehall Medical Equipment are too hot, there are a couple of potential causes. The thermostat might be set too high, so adjust the thermostat to a lower setting. Alternatively, the thermostat itself might be broken and need to be replaced.
What to do if Whitehall Medical Equipment water is cloudy?
If the water in your Whitehall Medical Equipment is cloudy, it could be due to two main reasons. The Thermo Packs might be worn out and seeping, in which case they need to be replaced. Another cause could be infrequent cleaning. To resolve this, drain, clean, and refill the unit.
Why Whitehall Thermalator LITTLE Therm Thermal Packs are too hot and then too cool?
If the Thermal Packs in your Whitehall Medical Equipment are alternately too hot and then too cool, the most likely cause is a broken thermostat, which will need to be replaced.
How to remove rust from Whitehall Thermalator LITTLE Therm?
If you find rust in your Whitehall Medical Equipment unit, it's likely due to contact with ferrous metal. Remove the ferrous metal item—usually a staple, paper clip, safety pin, etc.—from the unit and then clean the unit thoroughly.
General| Brand | Whitehall |
|---|---|
| Model | Thermalator LITTLE Therm |
| Category | Medical Equipment |
| Language | English |
Remove all shipping material and clean the unit thoroughly before use.
Place the unit on a level, scratch-resistant surface using the handles.
Condition each Thermal Pack by soaking in water before first use to allow swelling.
Includes checking water levels and discarding contaminated packs.
Involves cleaning the wire rack and scrubbing thermal packs with soap and water.
Includes replacing worn packs and having an electrician check unit components.
To Next Page
