6026-2415 Natural Wood Drying Rack ©2012 Whitmor, Inc.
A 5 ea
Long hanging bar
B 1 ea
Medium hanging bar
G 16 ea
Locking collar
(Inserted into parts E & F)
H 6 ea
Collar ring
I 6 ea
Screw
C 2 ea
Short hanging bar
D 3 ea
Center hanging bar
E 1 ea
Left side frame
F 1 ea
Right side frame
This product is intended
for drying laundry.
Tools Needed:
Phillips Screwdriver,
and Coin or Standard
Screwdriver
STEP 1 Begin with the right side
frame (F) and place it on a hard,
flat surface like the floor. Make
sure all locking collars (G) are
inserted correctly as it came from
the box. Place 3 collar rings (H)
over exposed locking collars on
right side frame. Snap five long
hanging bars (A), one medium
hanging bar (B) and two short
hanging bars (C) into locking
collars (G) in right side frame.
Place the three center hanging
bars (D) into center axis of side
frame. Secure center hanging
bars with three screws (I) using a
Phillips screwdriver (not
included).
I I I
I
A
A
D D D
H
F
A
A
C
C
B
A
H
H
H
H
H
STEP 2 Next, place 3 remaining
collar rings (H) over exposed
locking collars on left side frame
(E). Place left side frame (E) onto
each hanging bar snapping in place
just like the right side was done.
Secure center hanging bars with
three screws (I) using a Phillips
screwdriver.
D
D
D
E
II
Page 1
NOTE: Make
sure the tabs on
end of hanging
bars (A, B, & C)
line up with
notch in locking
collar (G).
To Next Page
Need help?
General
