why pro WHY-EP - Rolling Complex Duplicating Procedures; BFT Rolling Complex Duplication; V2 Rolling Complex Duplication; Activating on Receiver (D.O.R.)

To Next Page

To Previous Page

WHY-EP

ROLLING COMPLEX

DUPLICATING PROCEDURES

1. While pressing the button 1 of the “WHY-EP”, at the same time press 4 times the 2 button.

2. Release both buttons. Now the WHY-EP LED will emit a short ﬂash every 2 seconds.

3. Place the original remote control to be programmed in front of the “WHY-EP”, at about 5 cm of distance (as shown

in the picture).

4. Press and retain pressed the button to be programmed of the original remote control, till the LED will switch on as a

ﬁx light; now release the button.

5. The WHY-EP LED will emit a short ﬂash every 2 seconds. That it informs the user that, to duplicate the remote

control, it is necessary to emit the SEED CODE to realize the copy.

6. Transmit now the SEED CODE of the BFT original remote control, using a pin, press the rear hide button (see the

picture) or, according to the new references, press the 1 and 2 buttons until the original remote control LED switches

on. (see the picture)

7. Now the WHY-EP LED will change the ﬂash mode (more fast), for a reconﬁrmation of the correct code learning. This

step may take some seconds.

8. At this moment, press the WHY-EP button when you want to store the code and retain pressed until the WHY-EP LED

switches o.

9. Activate now the

procedure to insert the new remote control on the receiver.

BFT

To activate the remote control on the receiver for models marked with

proceed as below:

1. First of all you must be closed to the automation.

2. Press and retain pressed the programmed button during 10 seconds, when the LED start to ﬂash, release the button.

3. Wait until the LED will turn o. The operation has been done, now you can use your new remote control.

To activate on the receiver all the other models: Refer you to the instructions of the original model.

NOTE: THE SEED CODE OF THE WHY-EP CAM BE EMITTED AS HERE BELOW:

1. Press the buttons 1 and 2 simultaneously for 8 seconds and release them when the LED start to ﬂash;

2. While the LED is ﬂashing press the button with the seed code needed.

ATTENTION!! Every kind of receiver can have the “radio-mode” disarmed. In this cases will be necessary insert the new remotes controls with the “manual procedures”.

433 - 868