To Next PageTo Next PageWhat to do if my Whynter Ice Maker won't operate?
If your Whynter Ice Maker isn't operating, try the following: * Plug the ice maker in. * Replace the fuse. * Turn the ice maker power switch to ICE (ON). * Remove any ice from the ice full probe.
Why does my Whynter Ice Maker make ice, but the ice storage bin never fills up?
If your Whynter Ice Maker makes ice, but the ice storage bin never fills up, the condenser may be dirty, so you should clean it. Also, check the installation and run the unit for a longer period.
What to do if water is leaking out of my Whynter UIM-502SS?
If water is leaking out of your Whynter Ice Maker, humidity may condense on the door under some conditions; consider moving the unit or being more careful when opening the door. Also, tighten the fitting, referring to 'Connecting the water line'.
How to fix noise during Whynter UIM-502SS operation?
If you notice noise during your Whynter Ice Maker operation, level and lock the feet. See 'Leveling the Ice Maker.' Also, see 'Normal Sounds.'
Why are the cubes from my Whynter Ice Maker partially formed and white at the bottom?
If the ice cubes from your Whynter Ice Maker are partially formed and white at the bottom, check if the water supply pressure is below 15 psi. Also, check the water supply to see if the filter may be restricted, and check for a water leak at the water trough. You can also change the ice size thickness to medium or large.
Why does the Whynter UIM-502SS not feed in water after it starts?
If the Whynter Ice Maker does not feed in water after it starts, turn on the water supply tap and reconnect the water supply pipe.
Why do minerals build up quickly inside my Whynter UIM-502SS Ice Maker?
If minerals build up quickly inside your Whynter Ice Maker, it's likely that the mineral level in the water is too high. Change the inline water filter every 3-6 months or as needed.
What to do if the Whynter Ice Maker stops suddenly while making ice?
If your Whynter Ice Maker stops suddenly while making ice: * Reconnect the power supply line if the electricity is off. * If the room temperature is out of the stated range, cut off the electricity and let the ice maker stop working until the temperature returns within the stated range.
What to do if the body of the Whynter Ice Maker is electrified?
If the body of your Whynter Ice Maker is electrified, it might be because the ground line isn't in the socket. Use the correct plug and outlet.
General| Model Number | UIM-502SS |
|---|---|
| Type | Portable Ice Maker |
| Ice Production Capacity | 50 lbs per day |
| Water Reservoir Capacity | 2.2 liters |
| Water Source | Manual Fill |
| Refrigerant | R134a |
| Voltage | 115V |
| Material | Stainless Steel |
Specifies required clearances for proper ventilation and service access.
Details electrical input, power consumption, dimensions, weight, and ice-making capacity.
Explains the importance and method of proper grounding for electrical safety.
Guides on adjusting the leveling legs for proper appliance operation and stability.
Instructions for installing the included NSF certified water filter for water quality.
Procedures for draining the ice maker, especially for storage or proper waste water disposal.
Guidelines for installing the ice maker in a standalone location.
Guidelines for installing the ice maker under a counter or in a cabinet.
Guidelines for integrating the ice maker into cabinetry with proper ventilation.
Explains the function of indicator lights and control buttons on the ice maker.
Details how to adjust the thickness of the ice cubes produced by the machine.
Step-by-step guide on how to start and operate the ice maker.
Explains the water flow and freezing process within the ice maker.
Describes typical sounds the ice maker may produce during operation.
Instructions for draining and preparing the unit for extended periods of non-use.
Guidance on cleaning the outer surfaces of the ice maker.
Instructions for cleaning the ice storage bin and water trough.
Procedures for cleaning the condenser to ensure optimal performance and prevent failure.
Steps to clean the water distribution tube if ice formation is incomplete or output is low.
How to clean mineral scale buildup from the internal water system.
