Wiiboox WiibooxSweetin User Manual

Operating light
Touch screen
Tray
Power switch
Cartridge slot
USB
Power port
FRONT BACK
Preparation
1 Please complete the following steps before turn it on
Note: Customer can upload image through this URL or QR code
2
3
4
5
① Please take out the protecting foam from position A
Please conncet to the electricity (As shown in figure 2 ）
Please install
Connect WiFi
Obtain the unique machine URL and QR code under
Settings Interface
figure 2
A
Protecting foam
figure 1
Attention: Please stuff back the protecting foam before transit
（As shown in figure 1）
Introduction
Usage
1
2
3
Upload image simply by scanning QR code
or input URL.
Select the image and adjust the cup size, image
brightness and contrast.
Create high resolution image or text in seconds onto
your favorite frothy beverages,both hot and cold.
Maintenance
Put the new cartridge into soltTake out the cartridge from slot
Cartridge slot Put the new cartridge into solt
Turn on
1 2 3 4 5
6 7 8 9
10
Take out PE foam Plug in power Connect wifi
Scan QR code,
upload image
Choose image Place the cup full of drinks
on the tray
Click Printing Finshed
( after " Please wait......")
Instructions
Take out the ink cartridge,
enter the SN code and
tear off the blue ribbon.
ink cartridge
1.Replace ink cartridge
Each ink cartridge can print about 800 cups. You can replenish it
from WiibooxSweetin Amazon Store.
2.Daily maintenance of cartridge
Please wipe the nozzle of the cartridge with a clean and moistened
paper towel before daily use to prevent blockage.
WiibooxSweetin Coffee Printer User Manual

Wiiboox WiibooxSweetin Specifications

General

Brand	Wiiboox
Model	WiibooxSweetin
Category	3D Printers
Language	English

Summary

Getting Started: Initial Setup and Instructions

Unpacking and Powering On

Steps include removing PE foam, plugging in power, and turning on the device.

Connectivity and Image Upload

Connect to Wi-Fi and prepare images by scanning QR codes or inputting URLs.

Printing Process

Select images, adjust settings, place the cup, and initiate printing.

Device Overview and Preparation

Introduction to Components

Diagram identifying key parts like touch screen, operating light, and cartridge slot.

Pre-Operation Checks

Steps before turning on: remove foam, connect power, install cartridge, and connect Wi-Fi.

Usage and Maintenance

Core Usage Steps

Upload images via QR/URL, select and adjust images, then create high-resolution prints.

Ink Cartridge Management

Replace ink cartridges (print ~800 cups) and perform daily nozzle cleaning.

Product Specifications and Safety

Product Parameters

Details on model, dimensions, weight, network, and electric specifications.

Special Instructions and Restrictions

Guidance for transportation, use, setting, power supply, and usage restrictions.

Warranty Information

Terms for warranty service, including coverage and non-warranty conditions.