Wiko wishake - Basic Operations; Turning the Earphones On and Off; Charging the Device

Hello! Let’s see how it works…
1. Basic operations
~ Turn ON
To turn on WiSHAKE TW earphones, please press the
multifunction button on each earphone once. You will
hear a four tone rising scale and the LEDs will flash white
3 times.
The LED in both earphones will blink red and white once
per second.
~ Turn the earphones OFF
To turn off your earphones, please long press the multi-
function button for 3 seconds. You will hear a four-tone
falling scale and LEDs will flash white for 7 times.
Note: When the earphones are on and not connected to
a device, after 10 minutes of inactivity, they will turn off
automatically to save power.
~ Charging
• Charging dock
To charge the charging dock, please connect to a computer
or power source via USB. The colour of the LED in the
middle indicates the battery level. To know the battery
level, please refer to the following table:
To see the charging dock battery level without charging,
please press the button. The colour of the LED will turn on
for 5 seconds and then turn back off.
• Earphones
To charge WiSHAKE TW earphones please place them in-
side the Wiko charging dock and make sure they sit correct-
ly in the pin connectors. To activate the charging function,
Battery
Level
Led
Colour
During
charging
Not charging
(Press button)
< 25 %
Red Flash
Illuminates for 5
seconds
26 to 85 %
Blue Flash
Illuminates for 5
seconds
86 to 99%
White Flash
Illuminates for 5
seconds
100%
White Continuous
Illuminates for 5
seconds