Wilderness Systems PHASE 3 - Route and Secure Riser Bungee; Attach and Test Double Buckle Strap

Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 Rev. 06/17#59504276
4. Riser with looped bungee (front view)
5. From the backside of riser, insert one 1/4” bungee with hooks through top outer hole of the seat back riser.
6. Flip riser over. Tie a single knot on the front side of riser (Knot should fit inside the recess on the front of the riser).
7. Repeat step 6 for the hole on the opposite side. (Both knots should be visible on the front side of riser).
8. Finished riser with bungee attached