• If you need to adjust the angle of your seat or the position of the seat on the rails,
loosen the nuts on both sides of the seat, move the seat to the desired angle/position,
then tighten the nuts. The nut’s location is shown below.
• Ensure all cables and connectors at the front of the bike are securely connected
or certain components may not work including the front light, the motor inhibitor
switches, LCD display, and throttle. The motor inhibitor switches shut the motor off
as soon as the rider hits the brakes. If these switches are not operational it will
take longer to slow down which in some riding situations could cause injury
or death to the rider. If you have installed any accessories make sure they
do not interfere with all cables and connectors when turning the handlebars.
7
To Next Page
Loading...