YOUR FIRST RIDE
To use your electric bike:
1. Read the entirety of this manual before taking your first ride.Especially the Safety,
Folding and Unfolding the Bike, Preparing to Ride, and Operating Safety sections.
The page number of these sections can be found by referring to the table of contents
at the beginning of this manual.
2. Check that the tire and the tire bead are seated just inside the rim. Inflate your bike tires
to a pressure that is within the recommended range printed on the side of the bike tire
sidewalls. When inflating, gradually inflate in 5-10PSI increments while checking to
make sure the tire bead is fully seated on the rim. If you notice the tire bead is not fully
seated at any point during inflation, deflate the tire completely and reseat the tire bead
before reinflating.
3. Check your seatpost clamp and handlebar stem quick releases. Unlatch the quick
releases and tighten by turning the bolt clockwise. The page number of this section
can be found by referring to the table of contents at the beginning of this manual.
4. Ensure both your seatpost and handlebar stem are inserted past their minimum
insertion points as indicated by the markings on them. Reference the Preparing to
Ride section of this manual for photos and complete instructions. Failure to insert
past the minimum insertion point will place undue stress on these components
increasing the risk of sudden failure potentially resulting in harm, injury, or death.
5. Check to make sure your frame folding latch and handlebar folding latch are locked.
Reference the Folding and Unfolding the Bike section of this manual for photos and
complete instructions. The page number of this section can be found by referring to
the table of contents at the beginning of this manual. Double check to make sure both
latches are secure and locked before riding. Failure to do so may result in the bike
folding while in use potentially causing serious harm to the rider.
6. Ensure your battery is fully charged before your first ride.
7. If the battery is not already placed at the battery base, slide it on the base and lock it
in position. Make sure the battery is all the way set at the base. Once the battery is
secured set, insert the key into the battery via the port on the battery. See the Battery
section of this manual for further information on the operation of the battery
13
To Next Page
Loading...