8. Set the battery on the battery case and turn it to the ON position. You will not be able
to remove the keys from the battery in this position.
Note:
• The key has to be inside the battery and turned to the ON position in order to
operate the bike. In this position, you will not be able to remove the key from the
bike. See the Battery section of this manual for further information. The page
number of this section can be found by referring to the table of contents at the
beginning of this manual.
• Before transporting the bike on a bike rack, remove the battery from the bike.
9. Hold down the power button on the button pad located on the left handlebar until the
display comes on.
10. Select a level of pedal assist using the plus and minus buttons on the button pad.
Pedal assist level 1 is the lowest level of assist and pedal assist level 5 is the highest
level of assist. Level zero will provide no assistance.
11. Turn off the power when the eBike is not in use. This will prevent accidental motor
engagements from occurring.
12. The right handlebar features a thumb throttle. Press the throttle slowly according to
how much speed and acceleration you want to achieve. The deeper you press the
throttle 、from its resting position, the more power propels the bike forward. When the
eBike is at a complete stop, turn the display off. This will ensure that the motor will not
activate until the display is turned back on and the rider is ready to go.
( Note: Exercise extreme caution using the thumb throttle. When at a complete
stop with the bike turned on, be careful not to press the throttle unknowingly or
the bike could throw you off balance and cause serious harm, injury, or death.)
13. To turn on the headlight and tail light, press the light button on the right side of the
button pad. The battery must be inside the bike.
Use caution to not engage walk mode unknowingly. This mode is engaged by
holding the minus button on the display control pad and will engage the motor
up to a walking speed.
FRONT AND REAR LIGHTS
The WILDEWAY electric bike comes with fully integrated front and rear lights. WILDEWAY
eBikes strongly recommends using these lights when riding at night or in low visibility
situations. To turn the lights on, hold the light button on the on the right side of the
display control pad until the lights turn on. To turn the lights off, repeat.
14
To Next Page
Loading...