WildGuarder GUARD1 Series

Questions and Answers

B
Brandon MartinAug 3, 2025
How to fix WildGuarder GUARD1 when photos do not capture subject of interest?
- M
  Mitchell MorganAug 3, 2025
  To ensure your WildGuarder Scouting Camera captures the subject of interest, consider these points: * Adjust the “Sensor Level” (PIR sensitivity). Use “High” for warm environments and “Low” for cold weather. * Avoid heat sources in the camera’s view. * If near water, aim the camera over ground. * Mount the camera on stable objects like large trees. * At night, reduce sensor sensitivity to match IR illumination range. * Reorient the camera if the rising sun or sunset triggers the sensor. * If the subject moves quickly, move the camera back or redirect it.
L
Lisa BrownAug 11, 2025
What to do if my WildGuarder Scouting Camera stops taking images?
- M
  Michael LawsonAug 11, 2025
  If your WildGuarder Scouting Camera stops taking images, here are some troubleshooting steps: 1. Ensure the SD card isn't full or turn on Cycle Recording. 2. Verify that alkaline, NiMH, or lithium AA batteries have sufficient power. 3. Confirm the power switch is in the “On” position, not “Off” or “Test”. 4. If GPRS is enabled, note the 1-minute interval between photos; turn off GPRS for continuous shooting. 5. Format the SD card using the camera.
A
Angelica HoustonAug 22, 2025
Why is the night vision flash range on my WildGuarder GUARD1 not meeting expectations?
- J
  Jeffery FullerAug 22, 2025
  If the night vision flash range of your WildGuarder Scouting Camera is not as expected, consider the following: * Install 8 AA batteries, as 4 may not suffice for night vision. * Ensure batteries are fully charged. * Set Night Mode to “Max Range” for better IR flash range. * Use high-quality 1.5V NiMH or Lithium rechargeable AA batteries instead of alkaline. * Mount the camera in a dark environment, avoiding light sources. * Ensure surroundings within flash range (trees, walls) reflect the flash back.