2.
3.
1.
2.
To enter any lowercase and uppercase letter, press ONCE a corresponding digit (E.g. to enter
A, a, B, b, C or c, press once 2)
To enter special characters (%, ^, &, etc), press the key (*)star
Example: if user password is 4Ag7$Zl@, then you have to dial 4247*
Dial 1 to use this phone, when requested
After a few seconds, extension is displayed on the phone’s screen; the phone is now assigned and can be
used to make and receive calls.
BLF / Function keys
BLF / Function keys must be set by user in Collaboration or by PBX administratorSettings Function keys
via WMS. Detailed information on setting Function keys: .Collaboration - User Guide
For WP490 with extension module, you can additionally set up up to 40 BLF keys on each extension
module (up to 3 modules are supported). Detailed information: WHS, WP490EXT, WPEHS - Quick Start
Guide
BLF / Function keys allow you to monitor users and features, make a call, transfer a call, pick up a call, park
a call, change status of features.
WP410 supports up to 4 BLF keys distributed on 2 pages, WP480G supports up to 16 BLF keys distributed
on 2 pages, WP490G supports up to 30 BLF keys distributed on two pages, refer to Appendix 1 - BLF keys
for detailed information on BLF key distribution for each phone.
List of function keys:
Colleague: monitor call status (incoming call / in call), make a call, transfer a call, pick up a call, check
who is calling
Park Location: park a call and resume
Line: press to use this line (to place a new call)
Speed Dial: press to call a speed dial number; additionally you can set up shortcuts in combination
with Feature Codes supported by the system, read Feature Codes notes for more information.
Trunk: monitor status of trunk (except for SIP trunks) and place a call via this trunk
Timetable / Switch / 3 state switch: monitor the status of switch / timetable, press to change status
Group pick up: press to pick up a ringing call of a user from your ACL group (feature works for users
registered to the same PBX and normally allows you to answer a ringing call for another user located
in the same office)
Call group: monitor call status (incoming call / in call), make a call, transfer a call, pick up a call,
check who is calling
Send DTMF: press to send DTMF tone
Call management
Place a call
Lift the handset
To Next Page
Loading...
