EasyManua.ls Logo

Wilesco Z360 User Manual

Wilesco Z360
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Caution!
Safety indications:
1.Before operation it is absolutely necessary to read carefully
this instruction and especially the safety indications.
2. This remote control device is exclusively meant and authori-
zed for the operating of RC-steam models by Wilesco. Wilhelm
Schröder GmbH & Co.KG assumes no liability in case of diffe-
rent use.
3. For safety reasons, children (recommended age: from 12 years on) should
operate this remote control only under supervision of adults.
4. Operating this remote control requires technical knowledge cautious acting. Faults
or carelessness during installation and operation can result in considerable damage to
property or persons.
5. Also operating the receiving device without the radio transmitter online can cause
problems or injuries.
6. In case of abnormal operation it is expressly referred to these dangers, any warranty
expires.
7.Each irregularity during operation must exclusively be repaired by a competent and
authorized person or by WILESCO themselves. Otherwise any warranty expires.
Nonwarranty clause
8. Since it is impossible to control handling, respect of installation and operation hints,
application and maintenance, Wilhelm Schröder Gmbh & Co.KG assumes no liability
for loss, damages or costs. Any claim for compensation resulting from operation,
application or remote damages is refused. No liability is assumed for damages to
persons or property or for consequences.
9. Unless legally admitted and regardless of the cause in law the obligation to
indemnification is limited to the invoice value of the product which is immediately
concerned with the event.
10. It is absolutely necessary to keep this operating instruction.
Operating instructions
11. Unscrew the cover
of the battery
compartment and insert
a 9-V-monobloc
battery. Fix the cover
with the screw and
screw the antenna in the
thread.
12.Switchonthe
transmitter (position
on). The LED has to
come up. The right
switch controls the right
/ left direction, the left
switch controls the
forward / backward
direction.
13. Unscrew the cover
of the battery
compartment and
insert 2 1,5-V-
batteries type AAA
(observe correct
polarity+/-).Fixthe
cover with the screw.
14. Only for
supplementary set
Z363 to steer forward
and backward:
connect up the jack
plug.
15. The relevant installation instruction is described in the notes of each model (pages
3-6).
Use of batteries
16. Non-rechargeable batteries are not to be recharged.
17. Different types of batteries or new and used batteries are not to be mixed.
18. Only batteries of the same or equivalent type as recommended are to be used.
19. Batteries are to be inserted with the correct polarity.
20. Exhausted batteries are to be removed from the toy.
21. Supply terminals are not to be short-circuited.
Telecommunication regulations
22. Please observe the telecommunication regulations in the country in which you
want to drive your model. Theuserisresponsibleforthedueuseoftheradio
remote control. Please observe the legal situation in your country.
Indication of waste disposal
23. Environment protection also concerns Wilesco. You have the possibility to return
to us the remote control and also the original packing (freight charges are not
reimboursed). All returned remote controls / packing are professionally recycled. You
can also dispose of the electronic components professionally and according to the legal
prescriptions yourself by taking them to the recycle boxes in your community.
This model is meant for the above described purpose only.
Technical specifications subject to change without prior notice.
Schützenstraße 12 E-Mail: info@wilesco.de
D-58511 Lüdenscheid www.wilesco.de
Remote Remote Control Z360
forward
backward
only with
supplement Z363
right left
only with supplement Z363
Question and Answer IconNeed help?

Do you have a question about the Wilesco Z360 and is the answer not in the manual?

Wilesco Z360 Specifications

General IconGeneral
BrandWilesco
ModelZ360
CategoryRemote Control
LanguageEnglish

Summary

Safety and General Information

General Safety Instructions

Essential safety indications and general operation advice for the remote control device.

Battery Usage and Handling

Guidelines for proper battery installation, usage, and disposal.

Telecommunication and Legal Compliance

Adherence to country-specific telecommunication regulations and legal aspects.

Assembly for Steam Roller "Old Smoky"

Disassembly of Chain Steering

Procedure for removing the chain steering mechanism before installation.

Drill-hole for Steering Wheel

Guidance on drilling the correct hole for the steering wire on the model.

Receiver Module Installation Part 1

Initial steps for mounting the receiver module onto the steam roller model.

Receiver Module Installation Part 2

Further steps for securing the receiver module using M2.5 screw.

Steering Wire Installation

Steps for inserting and connecting the steering wire to the receiver.

Steering Adjustment

Procedure for correctly adjusting the steering mechanism for proper operation.

Assembly for Traction Engine/Showman's Engine

Chain Steering Removal for Engine Models

Procedure to remove chain steering for installation on engine models.

Holder Installation for Steering Wire

Mounting the holder for the steering wire on the front axle of the engine.

Receiver Module Mounting Part 1

Initial steps for attaching the receiver module to the engine model.

Receiver Module Mounting Part 2

Completing the receiver module attachment with M2.5 screw.

Steering Wire Bending and Installation

Steps for bending and installing the steering wire into the receiver box.

FCC Compliance Information