Wilfa BPF-1200S - Motor Protection and Servicing

5
4
EngelskEngelskEnglish
removing parts, and before cleaning.
 If the motor has overheated, the temperature
monitoring system will trigger and the motor will
stop. Switch off and unplug the appliance and
let the motor cool down. The motor temperature
monitoring system will reset after the blender
has been unplugged from the wall socket for
45minutes. After this time, the blender can be
used again.
 The blade is very sharp, so use caution
when handling the blade. Do not attempt to
disassemble the blade assembly or touch any
rotating parts.
 Any servicing should be performed by an
authorized service representative. Do not attempt
to disassemble, repair or modify the appliance.
 Always disconnect the appliance from the power
supply if it is to be left unattended and before
assembling, disassembling or cleaning.