Wilfa HAZE - Maintenance

14
EN
INSTRUCTION MANUAL · HUMIDIFIER
The ambient
humidity is too
high.
Humidier is working in
CONTINUOUS MODE.
Change the mode.
The humidity target is
too high.
Select a lower %RH target.
Room is not well-
ventilated.
Open a window to ensure
proper air ow for your
humidier or move the
humidier to a more well-
ventilated room.
Excess water tank has
spilled while lling the
water tank or replacing
the water tank back
onto the base.
Wipe off excess water from the
top and bottom of the base
before replacing the water
tank.
There is
condensation in
the room.
The room temperature
is too low.
Heat the room up.
The mist suddenly
stops coming out.
Programmed timer
period has run out.
Turn humidier on.
The water shortage
indicator is on.
Rell water tank.
The target humidity
level is reached.
Turn the humidier off, or
select a higher humidity level.
Incorrect humidity
level is being
displayed.
Room is larger than the
effective range of the
humidier.
Move the humidier to a room
which is with suitable room
size.
Moisture has built up
inside of the humidity
sensor.
Turn off the humidier and
allow the humidity sensor
to completely air dry before
resuming use.
The nozzle is facing the
direction of the humidity
sensor.
Turn the nozzle so that it is
facing away from the humidity
sensor.
Humidity sensor is
broken of defective.
Contact Customer Support.