Wilfa HAZE - Page 17

15
EN
HAZE · HU-400BC
Control panel does
not work.
Hands are too wet when
operating control panel.
Keep hands dry while
operating the control panel.
Humidier has
malfunctioned.
Contact Customer Support.
White dust
appears around
the humidier.
Water being used has a
high mineral content.
Use distilled water with the
humidier. If distilled water is
not available, use puried or
ltered water.
Humidier was not
properly cleaned after
last use.
Clean humidier.
Mist is coming out
from the base.
Water tank is not
positioned correctly.
Turn off and unplug the
humidier, then align the water
tank cover with its respective
opening in the inner chamber.
Mist fog coming
out from around
nozzle.
There are apertures
between the nozzle and
water tank.
Reposition the cover and
check if the nozzle is well
plugged in the cover.
The warm mist
function does not
produce warm
mist.
The humidier is in
warm-up phase.
Wait a few minutes till the end
of the phase.
The mist is too ne to
feel the warmth.
Increase the speed level.
The room temperature
is too cold, and the
mist may cool down too
quickly.
Increase the speed level and
heat the room up.
Display show error
code EF.
Too much water in water
basin.
Remove water tank and empty
water from the base.
Check and clean particles in
water outlet of water tank that
led to leakage. If no leaks,
replace into base.
The following is not considered faulty operation: