22
EN
INSTRUCTION MANUAL · HEAT PUMP
I FEEL button
• Press this button to start I FEEL function and I FEEL icon will be displayed
on the remote controller. After this function is set, the remote controller
will send the detected ambient temperature to the controller and the unit
will automatically adjust the indoor temperature according to the detected
temperature. Press this button again to cancel I FEEL function and icon will
disappear.
• Please put the remote controller near user when this function is set. Do
not put the remote controller near the object of high temperature or low
temperature in order to avoid detecting inaccurate ambient temperature.
When I FEEL function is turned on, the remote controller should be put
within the area where indoor unit can receive the signal sent by the remote
controller.
CLOCK button
Press this button to set clock time. “ “ icon on remote controller will blink.
Press UP or DOWN button within 5s to set clock time. Each pressing of UP or
DOWN button, clock time will increase or decrease 1 min. If hold UP or DOWN
button , 2s later, time will change quickly. Release this button when reaching
your required time. Press “CLOCK” button to conrm the time. “ “ icon stops
blinking.
Note:
• Clock time adopts 24-hour mode.
• The interval between two operations can ‘t exceed 5s. Otherwise, remote
controller will quit setting status. Operation for TIMER ON/TIMER OFF is the
same.
SLEEP button
Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel
the Sleep, circulate between these, after electried, Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool modes; sleep status after run for one hour, the
main unit setting temperature will increase 1 , two hours, setting temperature
increased 2 °C, then the unit will run at this setting temperature; In Heat mode:
sleep status after run for one hour, the setting tempera- ture will decrease 1 , two
hours, setting tempera- ture will decrease 2 , then the unit will run at this setting
temperature.
Sleep 2 is sleep mode 2, that is air conditioner will run according to the
presetting a group of sleep temperature curve.
To Next Page
Loading...
