Wilfa NARVIK 30 - Page 21

21
EN
HEAT PUMP · NARVIK 30 & 40
• When selecting “ ”, air conditioner is blowing fan at xed angle.
Horizontal louver will send air at the xed angle.
• Hold “ ” button above 2s to set your required swing angle. When reaching
your required angle, release the button.
Note:
• “ ” may not be available. When air conditioner receives this signal,
the air conditioner will blow fan automatically.
• Press this button continuously for more than 2s, the main unit will swing back
and forth from up to down, and then loosen the button, the unit present
position of guide louver will be kept immediately.
• Under up and down swing mode, when the status is switched from off to “ ”,
if press this button again 2s later, “ ” status will switch to off status directly; if
press this button again within 2s, the change of swing status will also depend
on the circulation sequence stated above.
TIMER ON button
“T-ON” button can set the time for timer on. After pressing this button, “ “ icon
disappears and the word “ON” on remote controller blinks. Press UP or DOWN
button to adjust T-ON setting. After each pressing on UP or DOWN button,
T-ON setting will increase or decrease 1min. Hold UP or DOWN button, 2s later,
the time will change quickly until reaching your required time. Press “T-ON”
to conrm it. The word “ON” will stop blinking. “ “ icon resumes displaying.
Cancel T-ON: Under the condition that T-ON is started up, press “T-ON” button
to cancel it.
TIMER OFF button
“T-OFF” button can set the time for timer off. After pressing this button, “
“ icon disappears and the word “OFF” on remote controller blinks. Press UP or
DOWN button to adjust T-OFF setting. After each pressing on UP or DOWN
button, T-OFF setting will increase or decrease 1min. Hold UP or DOWN button,
2s later, the time will change quickly until reaching your required time. Press
“T- OFF” word “OFF” will stop blinking. “ “ icon resumes displaying. Cancel
T-OFF. Under the condition that T-OFF is started up, press “T-OFF” button to
cancel it.
Note:
• Under on and off status, you can set T-OFF or T-ON simultaneously.
• Before setting T-ON or T-OFF, please adjust the clock time.
• After starting up T-ON or T-OFF,set the constant circulating valid.
• After that, air conditioner will be turned on or turned off according to setting
time. ON/OFF button has no effect on setting. If you don’ t need this function,
please use remote controller to cancel it.