Wilfa NARVIK 30 - Page 20

20
EN
INSTRUCTION MANUAL · HEAT PUMP
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. The TURBO icon is displayed on remote controller. Press this
button again to exit turbo function and the TURBO icon will disappear. If start
this function, the unit will run at super-high fan speed to cool or heat quickly so
that the ambient temperature approaches the preset temperature as soon as
possible.
UP/DOWN button
• Press UP or DOWN button once increase or decrease set temperature 1 °C
(°F). Holding UP or DOWN button, 2s later, set temperature on remote
controller will change quickly. On releasing button after setting is nished,
temperature indicator on indoor unit will change accordingly.
• When setting T-ON, T-OFF or CLOCK, press UP or DOWN button to adjust
time. (Refer to CLOCK, T- ON, T-OFF buttons)
button
Press this button to set left & right swing angle cycling as below:
Note:
• Press this button continuously more than 2s, the main unit will swing back and
forth from left to right, and then loosen the button, the unit will stop swinging
and present position of guide louver will be kept immediately.
• Under left and right swing mode, when the status is switched from off to
, if press this button again 2s later, status will switch to off status directly; if
press this button again within 2s, the change of swing status will also depend
on the circulation sequence stated above.
• The function is only available for some models.
button
Press this button to set swing angle, which circularly changes as below:
• When selecting “ ”, air conditioner is blowing fan automatically. Horizontal
louver will automatically swing up & down at maximum angle.
• When selecting “ ”, air conditioner is blowing fan at xed
position. Horizontal louver will stop at the xed position.
OFF
OFF