Wilfa NARVIK 30 - Page 19

19
EN
HEAT PUMP · NARVIK 30 & 40
• After selecting cool mode, air conditioner will operate under cool mode. Press
“UP” or “DOWN” button to adjust set temperature. Press “FAN” button to
adjust fan speed. Press “ ” / “ “ button to adjust fan blowing angle.
• When selecting dry mode, the air conditioner operates at low speed under
dry mode. Under dry mode, fan speed can’ t be adjusted. Press “ ” /
“ “ button to adjust fan blowing angle.
• When selecting fan mode, the air conditioner will only blow fan, no cooling
and no heating. All indicators are OFF. Press “FAN” button to adjust fan
speed. Press “ ” / “ “ button to adjust fan blowing angle.
• When selecting heating mode, the air condition- er operates under heat
mode. Press “UP” or “DOWN” button to adjust set temperature. Press “FAN”
button to adjust fan speed. Press “ ” / “ “ button to adjust fan blowing
angle. (Cooling only unit won’t receive heating mode signal. If setting heat
mode with remote controller, press ON/OFF button can’t start up the unit).
Note:
• For preventing cold air, after starting up heating mode, indoor unit will delay
1~5 minutes to blow air (actual delay time is depend on indoor ambient
temperature).
• Set temperature range from remote controller: 16~30°C (61-86°F);
• Under auto mode, temperature can be displayed; Under auto mode, set
temperature can be adjusted.
• This mode indicator is not available for some models.
FAN button
Press this button, Auto, Quiet, Low, Medium-low, Medium, Medium-high, High
speed can be circularly selected. After powered on, Auto fan speed is default.
Note:
• Under AUTO speed, air conditioner will select proper fan speed automatically
according to factory default setting.
• It’s low fan speed under dry mode.
• X-FAN function: Holding fan speed button for 2s in cool or dry mode, the
icon for X-FAN is displayed and the indoor fan will continue operation for a
few minutes in order to dry the indoor unit even though you have turned off
the unit. After energization, X-FAN OFF is defaulted. X-FAN is not available in
auto, fan or heat mode. This function indicates that moisture on evaporator of
indoor unit will be blowed after the unit is stopped to avoid mould.
• Having set X-FAN function on: After turning off the unit by pressing ON/OFF
button, indoor fan will continue running for a few minutes at low speed . In
this period, hold fan speed button for 2s to stop indoor fan directly. Having
set X-FAN function off: After turning off the unit by pressing ON/OFF button,
the complete unit will be off directly.