Wilfa NARVIK 30 - Page 25

25
EN
HEAT PUMP · NARVIK 30 & 40
8°C Heating Function
Under heat mode, press “TEMP” and “CLOCK” buttons simultaneously to
start up or turn off 8 C heating function. When this function is started up, “ ”
and “8C” will be shown on remote controller, and the air conditioner keep the
heating status at 8C. Press “TEMP” and “CLOCK” buttons simultaneously again
to exit 8C heating function.
Note:
• Under 8C heating function, fan speed is defaulted at auto speed and it can’t
be adjusted.
• Under 8C heating function, set temperature can ‘t be adjusted. Press
“TURBO” button and the remote controller won’t send signal.
• Sleep function and 8C heating function can’t operate at the same time. If 8C
heating function has been set under heat mode, press “SLEEP” button will
cancel 8C heating function. If sleep function has been set under heat mode,
start up the 8 C heating function will cancel sleep function.
• Under F temperature display, the remote controller will display 46F heating.
Childlock function
Press UP and DOWN simultaneously to turn on or turn off child lock function.
When child lock function is on, ” ” icon is displayed on remote controller. If
you operate the remote controller, the ” ” icon will blink three times without
sending signal to the unit.
Temperature display switchover function
Under OFF status, press DOWN and ”MODE” buttons simultaneously to switch
temperature display between °C and °F .
Autoclean function
Under unit off status, hold “MODE” and “FAN” buttons simultaneously for
5s to turn on or turn off the auto clean function. When the auto clean func-
tion is turned on, indoor unit displays “CL”. During the auto clean process of
evaporator, the unit will perform fast cooling or fast heating. There may be
some noise, which is the sound of owing liquid or thermal expansion or cold
shrinkage. The air conditioner may blow cool or warm air, which is a normal
phenomenon. During cleaning process, please make sure the room is well
ventilated to avoid affecting the comfort.
Note:
• The auto clean function can only work under normal ambient temperature.
If the room is dusty, clean it once a month; if not, clean it once every three
months. After the auto clean function is turned on, you can leave the room.
When auto clean is nished, the air conditioner will enter standby status.
• This function is only available for some models.