Wilhelmsen Ships UNTIOR HPC 67/1 User Manual (English)

Questions and Answers:

C
Christopher JonesAug 8, 2025
Why won't the motor start on my Wilhelmsen Ships UNTIOR HPC 67/1?
- C
  Christopher NashAug 8, 2025
  If the Wilhelmsen Ships Pressure Washer motor doesn't start, first ensure the plug is properly inserted and there is current. Then, check the oil level and add oil if needed. Verify that the mains fuse is switched on. Finally, if the overload protection has activated due to overheating, ensure the mains voltage and cleaner voltage are the same, then switch off the cleaner and let it cool for at least 3 minutes.
J
Joseph WebbAug 13, 2025
How to fix a pressure drop in my Wilhelmsen Ships UNTIOR HPC 67/1 Pressure Washer?
- N
  Nicole JamesAug 13, 2025
  If you experience a pressure drop with your Wilhelmsen Ships Pressure Washer, try venting the system by operating the spray gun several times at short intervals. If necessary, operate the cleaner for a short time without the high-pressure hose connected. Also, check and clean or replace the high-pressure nozzle if it's blocked or worn. Finally, ensure the detergent tank is full or set the detergent to “0”.
S
stuartjamesAug 20, 2025
What to do if the motor on my Wilhelmsen Ships Pressure Washer switches off?

General