To Next PageTo Next Page
Need help?Do you have a question about the Willhi WH1436H and is the answer not in the manual?
General| Model | WH1436H |
|---|---|
| Type | Digital Temperature Controller |
| Temperature Resolution | 0.1°C |
| Display | LED |
| Control Mode | On/Off |
| Hysteresis | Adjustable |
| Mounting | Panel Mount |
| Control Output | Relay |
| Output Capacity | 10A |
| Sensor Type | NTC |
| Power Consumption | ≤ 3W |
| Temperature Range | -50~110°C |
Indicates the controller's setting process or control process status.
Shows if the controller is supplying output power or not.
Use the SET button to enter menus, select parameters, and confirm values.
Use POWER to save settings, quit, or turn the controller on/off.
Use UP/DOWN to navigate parameters and adjust values rapidly.
Hold UP to view Hb and DOWN to view Lb when not in setting mode.
Procedure to reset all controller settings to their factory defaults.
Enable alarm by setting AL or AH; press any button to silence.
Focus on setting HC, Lb, and Hb for basic controller operation.
Example of setting up the controller to manage humidifiers.
Example of setting up for dehumidifier use with alarms.
Configures the controller for humidification (H) or dehumidification (C).
Sets the lower (Lb) and higher (Hb) bounds for humidity control.
Adjusts the humidity sensor reading for accuracy.
Defines the minimum on-off cycle interval for compressor protection.
Sets high (AH) and low (AL) humidity thresholds for audible alerts.
Checks for correct humidity levels, PT delay, and target conditions.
Indicates a sensor probe issue or defect.
Ensures the input power cord is securely connected.
Indicates humidity is below minimum or above maximum measurable.
Usually due to alarm settings; disable alarms by setting AH=100, AL=0.
Explains Lb must be less than Hb and how the controller auto-corrects.
