2
PUTTING ON YOUR PROSTHESIS
Before putting on your liner, make sure that your limb is clean, dry, and free of soap residue.
Do not apply any lotion, powder, or lubricant to the limb or to the liner. These products could damage
the liner.
1. Invert the Alpha Duo® Liner so that the logo is on the inside. Place the end of the liner against the end of
your limb.
The position of the logo does not matter. The logo can face to the front, to the back, or to the side.
Varying the orientation from day to day can prolong the life of the liner.
2. Carefully roll the liner up onto your limb. Make sure that there are no wrinkles or air pockets between the liner
and the limb.
DO NOT PULL the liner onto the limb. Pulling the liner may stretch the gel, causing pulling on the skin
and discomfort.
3. Invert the One Gel Sock so that the silicone side is facing out. Place the end of the inverted sock against
the end of the liner.
4. Roll the sock up onto the limb so that the silicone side is against the liner. Make sure that there are no
wrinkles or air pockets between the One Gel Sock and the liner.
6. Step into the
socket and pull
the sleeve up
onto the residual
limb.
7. If you have a LimbLogic pump, stand up into a full weight-bearing position. Then press the on/o switch
to turn on the LimbLogic pump. Read the LimbLogic instructions for more details.
5. Fold the large
end of the One
Sleeve down
onto the socket
to expose the
open end of the
socket.
One Sleeve
To Next Page
Loading...