Wilson Benesch Circle 25 - Nanotube One Anti-Skate Positioning; Step 14 (Nanotube One) Positioning

Step 14 (Nanotube One only)
IfyouarengaNanotubeOnethena
rule should be used to set the correct bias.
The measurement should be taken from the
nearside of the bearing housing or “egg” as
shown in the table below.
The thread should be held by the rubber
O-ringstopreventtheposionchanging.
ANTI-SKATEPOSITIONING(NANOTUBEONE)
Distance measured in mm from the side of the
egg shaped bearing housing.
8mm - 1g
11mm - 1.25g
14mm - 1.5g
17mm - 1.75g
20mm - 2g
23mm - 2.25g