Need help?Do you have a question about the Wilson Benesch Circle 25 and is the answer not in the manual?
General| Brand | Wilson Benesch |
|---|---|
| Model | Circle 25 |
| Category | Turntable |
| Language | English |
Lists components included in the turntable hardware pack for setup.
Lists components included in the tonearm hardware pack for setup.
Covers unpacking, plinth placement, and ensuring concentricity.
Details the correct method for attaching the drive belt to the pulley and sub-platter.
Guides on placing the platter and performing an initial power check.
Explains how to carefully thread the tonearm lead through the arm hub.
Details inserting the tonearm into the arm hub and securing it with the locking screw.
Guides on carefully connecting the cartridge wires to the tonearm pins.
Describes inserting and loosely tightening cartridge mounting screws.
Covers adjusting the bearing housing and locking collar.
Guides on fitting the counter-balance onto the balance beam.
Details counter-balance installation for the Nanotube One model.
Explains aligning the cartridge body parallel to grid lines using an alignment gauge.
Guides on adjusting cartridge overhang by tracking the printed arc.
Instructs on threading the anti-skate weight through the anti-skate beam.
Details placing O-rings and the anti-skate loop on the bias arm.
Explains setting anti-skate force based on tonearm weight grooves.
Provides specific distance measurements for setting the Nanotube One anti-skate.
Details warranty duration and the necessity of registration for extended coverage.
Lists conditions that void the warranty and outlines return process requirements.
Outlines specific warranty terms for demonstration units.
Covers disclaimers for implied warranties and consequential damages.
To Next Page