33
Two Torus Systems in Stereo Operation:
(Infrasonic Generator Connections & Positioning)
Both the left and right Torus Infrasonic Generators should be connected with loudspeaker cable,
as detailed on page 27 of this manual, to their respective Torus Amplifiers. This connection is
the same whether using high or low level connections or both.
Each Infrasonic Generator should be positioned next to your respective front left and front right
channel speakers so that they are adjacent to the center line of the coils in your loudspeakers
drive units. The diagram in figure 8 below shows the ideal positioning for two Torus Systems in
stereo configuration, however the effects of the room on the placement of the Infrasonic
Generators should be considered, as discussed on pages 29 and 30 of this manual.
To avoid an imbalance between the left and right hand channels the crossover frequency and
gain levels should be set at the same values on each Torus Amplifier. These controls are
detailed on pages 21 and 22 of the Torus Amplifier manual.
figure 8.
Line running through center of
coils of Torus & loudspeakers
Listening
Position
Torus
Channel
Channel
Torus
To Next Page
Loading...