34
Two Torus Systems Stagger Tuned:
(Amplifier Settings)
Using the crossover frequency control on the Torus Amplifier and the Parametric Equalizer on
the underside of the Torus Amplifier, one or more Torus Systems can be setup to operate within
a set frequency range.
This configuration will give a flatter response throughout the bass frequencies, as each system
is setup to work within a more narrow frequency range, putting less demand on the Torus
Amplifier.
There are no hard and fast rules here and experimentation is the key, as the settings that work
best will depend on your room and the equipment that you are partnering the Torus with.
The example in figure 9 below shows the setup for two Torus systems, where the signal crosses
over from the main system loudspeakers at 45Hz to Torus 1 and then crosses over from Torus
1 at 30Hz to Torus 2 which operates all the way down with no frequency roll off selected from
the parametric EQ.
For bypass, switch 4 must be set to the OFF position
and Switch 5 to the ON position. When in bypass mode
switches 1,2,3,6,7 and 8 have no effect.
figure 9.
Parametric EQ Switch Settings
Parametric EQ Switch Settings
High & Low Level
Input Crossover
Frequencies
High & Low Level
Input Crossover
Frequencies
To Next Page
Loading...