Step 6. Place bottom shelf with the caster sockets facing
up on a solid surface. Insert casters by hand, (casters with
brake should be on the same 18" long side). Fully seat
casters with mallet if necessary by tapping gently.
Step 7. Turn over so casters are on the solid surface.
Place legs over shelf bosses, one at a time and seat as
far as possible by hand. Fully seat with rubber mallet if
necessary.
Step 8. Take top shelf assembly and place bosses into
the holes at the top of the legs. Seat as far as possible by
hand, tapping with a mallet if needed to fully seat.
Step 9. Ax velcro to the 4 corners of the underside of the
cushion and to the 4 corners of the top of the top shelf, so
that they will match up. Place cushion on top of shelf and
press rmly in all 4 corners.
Finished WT16SC
To Previous Page
Loading...