Wilson Electronics WT16

To Next Page

ASSEMBLY INSTRUCTIONS

Tuffy Seat With Drawer

Figure 1

Bottom panel

DRAWER PARTS LIST:

1. (1) Left Bracket

2. (1) Right Bracket

3. (2) Side panels (L & R)

4. (1) Front Panel w/handle

5. (1) back panel

6. (1) Bottom Panel

7. (2) Extension Rails & Screws

8. (17) Drawer Screws

***READ INSTRUCTIONS BEFORE BEGINNING ASSEMBLY

***USE POWER DRILL IF POSSIBLE

THE EXTENSION RAIL NEEDS TO BE

DISASSEMBLED

FOR INSTALLATION. Extending the rails as far as

possible & push the black lever right to left, then

pull the two pieces apart. (Figure 1)

STEP 1: Place bottom of drawer on flat surface, flat side up.

STEP2: Attach back panel to bottom panel matching the wider lip

of the panel to the bottom and the thinner lip is facing what will

be the outside of the drawer. (Diagram right).

Attach side and

bottom panel from underneath with screws (direction of lower

arrow shown right)

STEP 3: Attach brackets to underside of top shelf as shown in

figure 3 (right)

STEP 4: Attach 1/2 of rail assembly without the black lever to

brackets as shown in figure 4 below.

Figure 3

STEP 5 - Attach 1/2 of rails with black lever to assembled drawer as

shown right.

STEP 6 - Fit rails together to slide drawer underneath shelf

CART PARTS LIST:

1. (1) shelf with handle

2. (1) bottom shelf with caster inserts

3. (4) legs

4. (4) 4" casters, two with brake

H. Wilson Company

555 West Taft Drive

South Holland IL 60473

Phone: (800) 245-7224

sales@hwilson.com

Side & back panels will fit to the bottom panel

following the direction of the arrow left.

Attach with screw from underneath

Figure 4

Figure 3

Back of shelf

Back of Drawer

Need help?

Do you have a question about the Wilson Electronics WT16 and is the answer not in the manual?

Summary

Tuffy Seat With Drawer Assembly Instructions

Pre-Assembly and Drawer Preparation

Read instructions, use power drill, and disassemble extension rail for installation.

Drawer Assembly Process

Assemble drawer by attaching back, side, and bottom panels, then attaching rails.

Seat Base and Cushion Assembly

Caster and Leg Attachment

Insert casters into the bottom shelf and attach legs to the shelf bosses.

Top Shelf and Cushion Installation

Attach top shelf assembly and affix velcro to secure the cushion to the shelf.