Win Power SWSB Series

Questions and Answers

S
Stephen McdowellAug 12, 2025
Why is my Win Power Controller not charging?
- C
  Chelsea ZamoraAug 12, 2025
  If your Win Power Controller isn't charging, start by checking the connection cable between the wind turbine and the controller to make sure it's tightly connected. Also, check the connection cable between the PV and the controller, ensuring it is also tightly connected. If the connections are good, verify that the wind turbine output voltage has reached the required charging voltage and that the system voltage is appropriate.
E
Ernest AndersonAug 16, 2025
How to troubleshoot no LED display on Win Power Controller?
- J
  James BarnesAug 16, 2025
  If there's no display on the LED of your Win Power Controller, several things could be happening. First, check the wiring to ensure the connection between the battery and the controller is secure. If that's not the issue, make sure the DC breaker between the battery and controller is turned on. Another potential cause is that the battery might be connected negatively; if this is the case, you'll need to change the internal fuse in the controller and then reconnect the battery correctly. If the keypad has failed, contact after-sales support and send the unit back to the factory for repair.
B
Brian PayneAug 20, 2025
What to do if the indicator light stays on, indicating overload on Win Power Controller?
- B
  Beth ConradAug 20, 2025
  If the indicator light on your Win Power Controller stays on, signaling an overload, check the load connection to ensure it is normal. If there is an overload, remove it and then press the “SET/RESET” button to restore output.
M
Mark WalkerAug 25, 2025
What does it mean if the indicator light flickers on Win Power Controller?
- D
  Daniel WilliamsAug 25, 2025
  If the indicator light on your Win Power Controller flickers, indicating a short circuit, check the connection. After checking the connection, press the “ SET/RESET ” button to restore output.
K
Kimberly MorganAug 27, 2025
What does it mean when nixie tube shows '5' on Win Power Controller?
- N
  Nicholas RandolphAug 27, 2025
  If the nixie tube on your Win Power Controller displays “5”, it means the battery is overcharged. Check if the unload indicator light is on; if it is, the system is functioning normally. If the unload indicator light is not on, check the battery voltage. Disconnect all parts and then reconnect them.
K
Kelli MooreAug 31, 2025
What does it mean if the indicator light is on, indicating overdischarge on Win Power Controller?
- M
  millerbrianAug 31, 2025
  If the indicator light is on, it signifies overdischarge. In this case, the battery can’t be used until it is fully charged. If the battery has been over-discharged for an extended period, it needs to be charged using a battery charger.
L
Lisa WillisSep 4, 2025
What does it mean when the indicator light keeps on and wind turbine is on unload status on Win Power Controller?
- C
  Chad OlsonSep 4, 2025
  If the indicator light stays on, indicating the wind turbine is in an unload state, the system should automatically recover after waiting for 10 minutes.
R
Robert SanchezSep 8, 2025
How to recover charge status when indicator light flickers on Win Power Controller?
- D
  Diane BrownSep 8, 2025
  If the indicator light flickers, indicating that the system is in manual brake status, press “READ” and “SET/RESET” simultaneously to revert to charge status.

Win Power SWSB Series Specifications

General

Brand	Win Power
Model	SWSB Series
Category	Controller
Language	English

Win Power SWSB Series - User Manual

Table of Contents

Questions and Answers

Win Power SWSB Series Specifications