8.
13
9.
14
10
11
12
What if WINBOT encounters frame that requires your attention.
obstructions?
When the product gets into trouble,
Under normal circumstances, WINBOT such as stopping in a place on the
will automatically maneuver around the window or in the corners, what do I
obstruction and continue its cleaning. do?
Why does the product fail to The product may get into trouble when
completely clean the door or window cleaning the door and window glass. In
glass? such cases, it will try to get out of trouble;
if it fails, your assistance will be needed.
1) The front pad could be dirty from
First, press RESET button to restart the
cleaning the glass and as a result is
product and the product should start
leaving a residue on the glass. Stop and
cleaning again.
replace the pad with a clean pad. 2) The
rear pad may be dirty or contain some Can WINBOT completely clean the
debris that is leaving marks on the glass. corners of the window glass?
You should replace the rear pad with a
WINBOT is programmed to clean the
clean pad. 3) Check that the treads are
windows as good and efficiently as
clean. They may also contain some
possible. There may be some
matter that will leave marks on the glass
circumstances that corners may not be
that the rear pad can not wipe off. The
totally cleaned. With the Remote, you
treads should be checked often for
can take control of WINBOT when it has
cleanliness and wiped with a damp cloth.
finished cleaning the window and drive it
4) The provided cleaning solution should
to those spots that need to be attended
be used when cleaning the glass. A dry
to. We feel that this will satisfactorily
cloth will only wipe dust and NOT clean
resolve your problem.
the glass. 5) WINBOT cannot clean paint,
stains, paper, or glue from the window.
You will have to continue removing these
Should you still encounter some
residues by hand as you have done
situations that have not been properly
previously.
addressed to your satisfaction, we ask
How to completely clean the door or
that you contact our Service
window glass?
Department where a Technician can
properly address your specific
WINBOT cannot clean paint, stains,
problem or question. Or call our
paper, or glue from the window. You will
service number.
have to continue removing these
residues by hand as you have done
previously.
How to store the product when not in
use?
The product must be cleaned and with the
switch in the OFF position. It needs to be
stored in a dry place away from heat and
strong sun light which can have a
detrimental affect on the unit.
When the product cleans the outside
of the window and the alarm goes off, I
may not be able to hear the alarm.
WINBOT has a feature that will visually
let you know if a problem occurs while
also sounding its alarm. The Indicator
light on the bottom of the unit will flash
red, letting you know there is a problem
.
.
.
.
.
17
EN
To Next Page
Loading...