PAGE 7
winchestersafes.com TS-30 & TS-45 Owner’s Manual
DELIVERY AND INSTALLATION (CONTINUED)
3. Your safe was shipped with the door closed and locked. Open the safe by following the
INSTALLING THE LOCK BATTERY instructions on page 9 and the ELECTRONIC LOCK OPERATING
INSTRUCTIONS found on page 10 of this manual.
4. Remove the safe from the pallet by rst opening safe the door. Find and remove the (4)
four decorative plugs in the safe bottom. Using a 17mm socket and ratchet, remove the
four lag bolts that secure the safe to the pallet. Reinstall the four decorative plugs. Next,
close the safe door and extend the locking bolts by rotating the handle counterclockwise.
With the assistance of one or more adults, slide the safe to one side of the pallet to
prevent it from tipping over. Tilt the safe over until the bottom side of the safe touches the
oor, and then tilt the safe over enough to allow the pallet to be removed from under the
safe. Tilt the safe back up and set at on the oor.
5. With a dolly substantial enough to support the size and weight of your safe, move the
safe to your desired location. Consideration should be given to the weight of the safe and
the type of ooring that the safe will be moved across. Wood, tile, carpet and other types
of ooring can be easily damaged and it is your responsibility to take whatever measures
necessary to prevent any damage. If your home is pier and beam construction, you should
place the safe in an area of the oor that you are sure will support the safe’s weight.
To maximize the re protection of your safe, we recommend you place it in the lowest
elevation in your home. In a home re, the coolest part of the re is in the basement area
and the hottest in the upstairs.
6. To maximize the burglary protection, and prevent the safe from tipping over, you should
anchor your safe to the oor. See winchestersafes.com for accessory anchor kit and bolt
down instructions.
7. Your new Winchester Safe is now ready to operate.
To Next Page