Wind Crest SA1000 - Remote Programming; Entering Remote Programming Mode; Remote Programming Sequence

Remote Programming of the SA1000 unit
The autodialler has the facility to auto-answer an incoming call, after 6-15 seconds.
Once the call has been answered, the programming mode can be instigated by a series of simple
commands via a simple Touch-Tone Telephone or a Mobile Phone.
The programming is by means of using the (DTMF) Touch-Tones from the calling telephone or a
management computer based system into the Lift car.
To enter into the Remote Programming Mode, a Remote Programming Access (RPA) Number,“v..vv#”
within a time period of 30 seconds. (v is any digit 0 to 9). The Default is 1234.
If the RPA is incorrect the system will go in the normal auto-answer.
If the RPA number is correct, the system will output two short Beep tones and wait for additional
command tones for a period of 30 seconds before exiting and going in the normal auto-answer mode, i.e.
line being connected to the speaker box, after the emission of a short tone.
Exiting from the programming mode is by either a command code sequence, or no activity for 30seconds
whilst in the programming mode. (Note, when entering the remote programming mode, the call duration
time period is suspended; and re-established when existing from the programming mode).
The following can be implemented once in the programming mode.
00# Terminate Programming Mode
vv Announce the Programmed number e.g. if 15 is entered; the system will produce “Beep 15
Beep 5627899 Beep” if the Phone number of the 5th number was 5627899.
Sequence of Events
1. Call the Unit using a simple phone. The call will be Auto-answered and you will be connected to the
Speaker.
2. Inform the person if in the area of the Unit that you are about to update the Emergency Telephone.
3. Key in the Remote Programming Access Number.
So key on your telephone 1234# The unit will respond by two beeps.
4. Program the parameters by keying in the strings as mentioned in the programming by Keypad section.
Note that RPA code cannot be programmed remotely.
5. Enter 00# to end remote programming.
Page 5/5