Wind Crest SA1000 - User Manual

Need help?

Do you have a question about the Wind Crest SA1000 and is the answer not in the manual?

Summary

Describes the physical configurations for surface and flush mounting.

Details the keypad interface for programming the unit's functions.

Information about the dedicated power supply unit for the SA1000.

Instructions for connecting the mains and battery to the power supply.

Explains the correct pin configuration for RJ45 connectors and wire colors.

Details how to interpret and connect the low battery status signal.

Programming up to five telephone numbers for emergency calls.

Configuration of automated test calls, including frequency and type.

Customization of features like Auto Jump, SP Bits, and Hot Line.

Setting up identification messages and voice prompts.

Procedure to access the unit's programming via phone using RPA number.

Step-by-step guide for updating parameters remotely using DTMF tones.

General