INSTALLATION INSTRUCTIONS
Before Using Your Wine Refrigerator
Remove any exterior and interior packing material.
Check to be sure the following parts are included:
4 slide out shelves.
1 instruction manual.
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLING YOUR WINE REFRIGERATOR
Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded. To level your appliance, adjust the front legs at the
bottom of the appliance.
Keep away from direct sunlight and sources of excess of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold or hot ambient temperature
may also cause the appliances not to perform properly.
This model is not meant to be built-in to cabinetry, recessed or put underneath a
counter. Additionally this model is not meant to be used in an enclosed area.
While the back of the unit does produce a minimal amount of heat, it still needs
to vent to an open area.
5
To Next Page
Loading...
Need help?
General
