3. Upper Wine Cooler Temperature Display
4. Lowers Wine Cooler Temperature
5. Temperature Set Button
6. Increases Drawers Temperature
7. Drawers Temperature Display
8. Lowers Drawers Temperature
Setting the Temperature Control
NOTE: The temperature readout indicates set temperature while
programming then reverts to the actual temperature.
1. To set the desired temperature press the Temperature Set button.
2. The Upper Wine Zone temperature display will start flashing.
3. Set the desired temperature by pushing the UP (+) or DOWN (-)
button.
4. The temperature increases or decreases 1°F with each push of the UP
(+) or DOWN (-) button.
5. Press the Temperature Set button again, the Lower Drawers Zone display
will start flashing.
6. Set the desired temperature by pushing the UP (+) or DOWN (-)
button.
7. The operating panel will automatically exit programming mode after being
idle for 5 seconds.
NOTE: Temperatures may fluctuate depending on whether the interior light
is ON or OFF and depending on the position of the bottles.
Reprogramming the Temperature Ranges
The default temperature setting for the upper and lower zones is 41°F -
72°F. The ranges can be modified to suit your wine and beverage storage
preferences; minimum temperature of 34°F (lower zone)/41°F (upper zone)
and a maximum of 72°F (both zones).
To Next Page
Loading...
Need help?
General
