Winegard ConnecT WF-AP01

To Next Page

www.winegard.com/connect

WINEGARD

ConnecT

™

Quick Start Guide

NOTE:

Before using your Winegard ConnecT WiFi extender, there may be some additional steps required to set up your Winegard

ConnecT extender for use. If you have further questions, consult the full installation guide.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment uses

and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following methods:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and devices.

• Connect the equipment into an electrical outlet on a circuit different

from that which the radio receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

this equipment.

Only channels 1–11 can be operated. Selection of other channels is

not possible.

This device and its antenna(s) must not be co-located or operating in

conjunction with any other antenna or transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set

forth

for an uncontrolled environment. This equipment should be

installed and operated with a minimum distance of 25 cm between the

radiator and your body.

This device and its antenna(s) must not be co-located or operating in

conjunction with any other antenna or transmitter except in accordance

with FCC multi-transmitter product procedures.

2452375

Rev0 8/16

Manuel disponible en français

au www.winegard/support

Need help?

Do you have a question about the Winegard ConnecT WF-AP01 and is the answer not in the manual?

Summary

FCC Statement and Caution

FCC Statement Compliance

Device complies with Part 15 of FCC Rules, must not cause harmful interference, and accepts received interference.

FCC Cautionary Notes

Modifications void authority. Only channels 1-11 usable. Device/antenna must not co-locate with other transmitters.

FCC Radiation Exposure

Complies with FCC exposure limits for uncontrolled environments. Maintain 25 cm distance from radiator to body.

System Setup Steps

Initial Device Connection

Turn on WiFi device, scan for networks, select default SSID, and connect using the password from the IDU label.

Accessing Router Interface

Open an Internet browser and navigate to 10.11.12.1 to access the router's status screen.

Network Scanning and Selection

Scan for available WiFi signals, select the desired network based on signal strength, and click CONTINUE.

Final Network Connection

Enter the network password if prompted. Wait for the system to connect to the chosen network for internet access.